Rep 6.11 Pwb Box - Xerox Phaser 790 Service Manual

REP 6.11 PWB Box

Parts List on PL 16.1
Removal
To avoid personal injury or shock, do not perform repair activities with the power switch
on or electrical power applied to the machine.
1. Switch off the machine power and disconnect the machine Power Cord.
2. Remove the Platen Glass (REP 6.1).
3. Remove the ADF Assembly (REP 5.1).
4. Remove the Right Cover from the Scanner (REP 6.2).
5. Remove the Rear Cover from the Scanner (REP 6.4).
6. Remove the connector cover (Figure 1).
1
Remove the screws (2) and connector cover
Figure 1 Removing the Connector Cover
Initial Issue
Phaser 790/DocuColor 2006
WARNING
8. Disconnect five connectors from the ICM Main PWB (Figure 2).
1
On the right side of the
Scanner, disconnect
the Ribbon Cable and
connectors
2
At the rear of the
Scanner, disconnect
the connectors (3)
Figure 2 Disconnecting the Connectors
10/00
4-43
3
Loosen the screw
on the bracket
underneath the
Ribbon Cable
Repairs and Adjustments
REP 6.11