DFI-ITOX G4S300-B User Manual page 8

1
Introduction
• Suppor ts non-ECC (x64) DIMM using 128Mb, 256Mb or
512Mb
• Supports unbuffered DIMMs
Density
Density Width
Single/Double
184-pin DDR
Expansion Slots
The system board is equipped with 1 AGP slot and 3 PCI slots.
AGP (Accelerated Graphics Port)
• Supports AGP 3.0 (AGP 4x and 8x) and AGP 2.0 (AGP 4x)
spec.
• Supports 1.5V AGP 8x (2.13GB/sec.) and AGP 4x (1066MB/
sec.) add-in cards.
AGP is an interface designed to support high performance 3D
graphics cards for 3D graphics applications. It handles large
amounts of graphics data with the following features:
• Pipelined memory read and write operations that hide
• Demultiplexing of address and data on the bus for nearly
Onboard Graphics Features
• Graphics memory
-
-
• Graphics controller
-
-
-
8
64 Mbit
X8 X16 X8
SS/DS SS/DS SS/DS
64/128MB 32MB/NA 128/256MB
memory access latency.
100 percent efficiency.
Note:
AGP 2x and 3.3V AGP cards are not supported.
Shares 1MB/8MB/16MB of the system memory in DOS
mode
Uses Dynamic Video Memory Technology (DVMT) in Win-
dows mode
Core frequency of 266MHz
350MHz integrated 24-bit RAMDAC
Analog display up to 2048x1536 @ 60Hz refresh
128 Mbit 256 Mbit
X16
X8
SS/DS SS/DS
64MB/NA 128MB/NA
256/512MB
512 Mbit
X16 X8 X16
SS/DS SS/DS SS/DS
512/1024MB 256MB/NA