DFI-ITOX G4S300-B User Manual page 28

Rev. a+ system board
Table of Contents

Advertisement

2
Hardware Installation
2.4.2 Jumper Settings for Selecting the CPU's Front Side Bus
These jumpers are used to select the front side bus of the CPU
installed on the system board. The default setting is Auto. The system
will run according to the front side bus of the CPU installed on the
system board.
28
CPU
Auto*
100MHz
133MHz
166MHz
200MHz
"*" denotes default setting
Important:
• If you are using a CPU whose frequency has been locked
by the manufacturer, overclocking will have no effect.
• Overclocking may result to the CPU's or system's instability
and are not guaranteed to provide better system
performance. If you are unable to boot your system due to
overclocking, make sure to set these jumpers back to their
default settings.
JP2 JP1
JP2 JP1
1
2
3
1-2 On
2-3 On
JP2
JP1
1-2 On
1-2 On
2-3 On
2-3 On
2-3 On
All Off
All Off
All Off
All Off
2-3 On
JP2 JP1
1
1
2
2
3
3
All Off

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents