DFI-ITOX G4S300-B User Manual page 13

Rev. a+ system board
Table of Contents

Advertisement

1.1.3 Intelligence
CPU Protection
To prevent CPU overheat and damage, the system will automati-
cally shutdown once it has detected that the CPU's temperature
exceeded the temperature limit pre-defined by the system.
Dual Function Power Button
Depending on the setting in the "Soft-Off By PWR-BTTN" field of
the Power Management Setup, this switch will allow the system
to enter the Soft-Off or Suspend mode.
Wake-On-Ring
This feature allows the system that is in the Suspend mode or
Soft Power Off mode to wake-up/power-on to respond to calls
coming from an external modem or respond to calls from a
modem PCI card that uses the PCI PME (Power Management
Event) signal to remotely wake up the PC.
Important:
If you are using a modem add-in card, the 5VSB power source
of your power supply must support a minimum of ≥ 720mA.
Wake-On-LAN
This feature allows the network to remotely wake up a Soft
Power Down (Soft-Off) PC. It is supported via the onboard LAN
port, via a PCI LAN card that uses the PCI PME (Power Manage-
ment Event) signal or via a LAN card that uses the Wake-On-
LAN connector. However, if your system is in the Suspend mode,
you can power-on the system only through an IRQ or DMA
interrupt.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
Introduction
1
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents