Table of Contents
Advertisement
Installation Information - General
Before installation
Unpack the appliance and components and check for damage. DO NOT install any
damaged items.
Check all components have been supplied and that you have the correct gas type.
Read these instructions to get an overview of the steps required before starting the
installation. Failure to follow these instructions could cause a malfunction of the
appliance. This could result in serious injury and property damage.
Specification information
Data Plate
Inside appliance - bottom panel front right hand side
Dimensions
H-645 mm, W-750 mm, D-277 mm
Fan Type
Tangential 2-speed, rating 28 W
Flue - Masonry
Rinnai strongly recommends the use of a Rinnai Flexiliner Flue system. Failure to meet this
criteria may result in an unsafe situation. Installation without a flexiliner flue is permissible
as long as the chimney is checked for soundness and ability to achieve a good draw.
Terminal 43 mm x 245 mm rear discharge (spigot)
Flue - Decorative
Natural draft twin skin flue. Termination, an approved 100 mm cowl must be fitted to
all installations. Decorative chimney installations require a Zero Clearance Box and Zero
Clearance Flue Kit. Flue dimensions, outer - 150 mm, inner - 100 mm.
Gas Connection
½ " BSP male flare to barrel union
Gas Type
NG or LPG
Noise Level
49 dB(A)
Power Consumption
High 80 W, Standby 4 W
Weight
39 kg
Rinnai New Zealand
Compact Op/Install Manual: 10170-C 02-09
10
Advertisement
Table of Contents
