Ember Placement - Heat & Glo GEM-42B Owner's Manual

D. Ember Placement
WARNING
Explosion Risk.
• Follow ember placement instructions
in manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Improperly placed embers interferes with proper burner
operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• There are two types of embers shipped with the unit.
Embers for the burner surface and Mystic Embers for
the floor of the unit.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces just in front of the port trail,
but not on or in between the ports. For best performance
do NOT place embers on the ports at the rear of the
burner. Failure to follow procedure will likely cause light-
ing and sooting problems.
• Place Mystic Embers on the floor of unit.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
36
®
onto the burner care
Heat & Glo • GEM-42B • 2096-900 Rev. H • 3/06