Jøtul C 550 Rockland Installation And Operating Instructions Manual page 11

Fireplace Chimney Preparation
1. Remove the existing damper and linkage compo-
nents from the fireplace. Alternatively, you can
wire the damper plate to lock it in the open
position. Thoroughly clean the firebox and
smokeshelf area with a wire brush.
2. If the fireplace has been modified to accommo-
date installation, use anchors or masonry nails to
attach the metal Fireplace Conversion Notice
Plate (PN 220508) to the back wall of the masonry
fireplace firebox where it will be readily seen
should the insert be removed.
3. If appropriate, install the damper sealing plate
according to the manufacturer's instructions. The
sealing plate may require trimming to accommo-
date your specific fireplace damper frame.
Masonry or Listed
HT Prefabricated
Chimney Cap
Damper linkage
removed and
plate is removed
or locked open
Figure 9. A fully-relined chimney is required in
Canada and highly recommended in the U.S.
Sealed
connection to
chimney cap
Attach
Fireplace
Conversion
Notice Plate
to Rear Wall
of Fireplace
Jøtul C 550 Rockland
11