Toyotomi FF-V30T Installation And Operation Instructions Manual page 9

function (the CLOCK light and the information
display will start blinking). Next, set the hours using
the button on the left ( hour) and the minutes using
the button on the right (
increase the value by one step.
down the button, the value will continue going up,
until you release
approximately 10 seconds the blinking will stop and
the setting will be locked. After switching off the
heater, the clock time will be displayed.
4. Igniting the heater
The heater is operated directly by the user.
However, the heat yield is controlled automatically in
accordance with the room temperature registered by
the temperature sensor.
Step 1: Switch the heater ON
Press the ON/OFF button. The current room tempera-
ture and the set temperature are displayed on the
information display.The ON/OFF light starts to flash,
after which the heaterwill switch on.
Note: (*) The start-up time depends on the room tem-
perature.
After 9-15 minutes, the heater will automatically select
the correct operating mode and the ON/OFF button will
now be illuminated continuously.
Room temperature:
under 0˚C 11 minutes
0˚C - 15˚C 9 minutes
15˚C 8.5 minutes
If no flames are visible after the start-up period, the
heater will deactivate and then restart automatically. If
flames are still not detected, the heater will deactivate
and will have to be restarted manually (error code E-2
on the information display).
Step 2: Setting the room temperature
The temperature setting can only be adjusted, when the
heater is burning. Use the adjustment buttons to adjust
the temperature. First press either of the two buttons to
switch on the function (the TEMP light next to the infor-
mation display will start blinking).
temperature using the button on the right ( min.) to set
the temperature to a higher setting and the button on
the left ( hour) to lower the temperature. Press once
to increase the value one step. After approximately 10
seconds the light will stop blinking and setting will
belocked. The available temperature settings range
from10˚C minimum to 32˚C maximum. When the heater
min.). Press once to
When you hold
the button again. After
Next, adjust the
has been unplugged (or after a power failure), the
temperature will reset to the factory setting of 20˚C.The
operating mode is automatically
accordance with the room temperature detected by the
room temperature sensor. The heater works in the
"HIGH" operating mode until the room temperature has
reached the desired level.
When the room temperature reaches the chosen setting
the heater automatically switches to the "MED" or
"LOW" operating mode in order to maintain the desired
temperature.
Step 3: The correct use of 'SAVE'
The 'SAVE' function allows you to limit the temperature.
When this function is activated, the heater will
automatically switch off, when the room temperature
exceeds theset temperature by 2˚C. Subsequently,
when the roomtemperature has dropped again to the
set temperature,the heater will automatically switch on
again. Activatethe 'SAVE' setting by pressing the
appropriate button.The SAVE indicator light will light up.
Switch off thefunction by pressing the SAVE button
once again.
Without the 'SAVE' setting your heater will
maintain the
approximation as well, by adjusting its
heating capacity.'SAVE' is an economy
setting, which you canuse when, for in
stance, you are not present in the room or to
keep it frost-free.
Step 4: The 'FUEL' indicator light
When the FUEL indicator light lights up, it means that
there is only fuel left for 10 more minutes. The count
down of the remaining heating time can be seen in the
information display. You remove the fuel tank and refill
it outside the living room. If you don't refill it,you will
hear an alarm signal every two minutes, warning you to
refill the removable tank and after 10 minutes the heater
will switch off automatically.
controlled
set temperature by
in
8