Toyotomi FF-V30T Installation And Operation Instructions Manual page 10

5. Timer operation
The timer allows you to switch on the heater automati-
cally at a preset time.
In order to switch on the timer, the correct time must
have been set and the heater should be off. Follow the
procedure below:
[1] Press the TIMER button. The TIMER light and the
information display will start blinking.
[2] Use the adjustment buttons to set the time at which
the heater must ignite. Use the button on the left
( hour) to set the hours and the button on the right
( min.) to set the minutes (interval of 10 minutes).
[3] Press the ON/OFF button while the information
display is blinking.
[4] After approximately 10 seconds the information
display will show CLOCK again and the TIMER
indicator light will light up, indicating that the timer
function has been activated.To clear the timer
setting, press the ON/OFF button once.
Note: When the room temperature is less
than 15˚C, the preset time is changed
automatically depending on the room
temperature in order to heat the room by the
desired time.
Room temperature
More than 15˚C
0˚C ~ 15˚C
Less than 0˚C
6. Room temperature sensor
The room temperature sensor is fitted with a 2.5 meter
cable. This is located on the back of the heater. Ensure
that the cable does not touch the outlet tube. The room
temperature sensor can be installed with cellotape or
with a wood screw.
Select the location where the sensor is to be installed in
such a way that it will not be exposed to direct sunlight,
draughts or the warm air flowing out of the heater.
9
Ignition time
Set time
10 minutes before set time
20 minutes before set time
7. Childproof lock
The childproof lock can be used to prevent children
accidentally changing the heater settings. When the
heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are
blocked then. If the heater has already been switched
off, the childproof lock also prevents accidental ignition
of the heater. Activate the childproof lock by pressing
the appropriate button and holding it down for more
than 3 seconds. The KEY-LOCK indicator light will
lightup, indicating that the childproof lock has been
activated. Switch off the childproof lock by pressing the
button and holding it down for more than 3 seconds
once again.
8. Switching off the heater
There are two ways to switch off the heater.
[1] Press the ON/OFF button. The information display
will show the CLOCK signal.
ventilator and the ventilator motor continue to
operate for approximately 3 minutes in order to cool
the heater down.
[2] Press the TIMER button, when you want to switch off
the heater and ignite it again with the timer the next
time. This not only switches off the heater, but it
also activates the timer function. You can change
the required time with the adjustment buttons.
9. Recovery after overheating
The heater is protected against damage caused by
overheating.
A sensor will activate if the temperature in the housing
exceeds 90˚C.
Step 1: Switch the heater OFF.
Step 2: Allow the heater to cool down.
Ensure that the metal housing has cooled
sufficiently before touching it.
Under normal conditions, a period of 30 to 45 minutesis
sufcompletely.
Step 3: Pull the heater plug out of the socket.
The air circulation