Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro SS 3200 Operator's Manual

Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 23).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 23).
1
G014970
Figure 23
1. Control arm shaft
2. Control lever
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to
the control arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever fore or aft (Figure 23). Tighten both
bolts to secure the control in the new position.
3. Repeat the adjustment for the opposite control
lever.

Pushing the Machine by Hand

Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
This machine has an electric brake mechanism and to
push the machine the ignition key needs to be in the
Run position. The battery needs to be charged and
functioning for the electric brake to be disengage.
2
3
4
3. Slotted, upper hole
4. Bolt
To Push the Machine
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the seat to locate the bypass levers behind the
battery, on the frame.
4. Move the bypass levers forwards and then out
to lock them in place as shown in Figure 24 to
disengage the wheel motors. Repeat this for each
lever.
5. Lower the seat and move the motion control levers
inward to the neutral position and turn the ignition
key to the run position. Do not start the machine.
The machine is now able to be pushed by hand.
1
G014479
1. Bypass lever locations
2. Lever position for
operating the machine
6. When finished, ensure the key has been returned
to the Stop position to avoid draining the battery
charge.
If the machine fails to move the electric brake
may still be engaged. If necessary the electric
brake can be released manually. Refer to the
Releasing the Electric Brake (page 33) procedure in
Drive Maintenance.
21
2
Figure 24
3. Lever position for pushing
the machine
3