Toro SS 3200 Operator's Manual page 37

2
3
4
Figure 50
Mower Decks with Two Blades
1. Blades side to side
2. Sail area of blade
5. Measure between the outside cutting edges and the
flat surface (Figure 50 ). If both measurements
are not within 3/16 inch (5 mm), an adjustment is
required; continue with this procedure.
6. Support the weight of mower deck by placing wood
blocks under the edges of the deck.
Note: Avoid placing the supports under any
anti-scalp rollers if present on the deck.
7. Move to the left side of the machine. Remove the
side carriage bolt and locking nut from the fixed
position and install it into the rear, slotted position
(Figure 51). Leave the lock nut slightly loose.
5
3
4
Figure 51
1. Hanger bracket
2. Slotted adjustment
position
3. Fixed position
1
G009682
3
2
4
3. Outside cutting edges
4. Measure from the tip of the
blade to the flat surface
here
G015323
1
2
4. Side locking nut.
5. Side carriage bolt
8. Loosen the rear locking nut on the hanger bracket
just enough to allow the hanger to be adjusted
(Figure 51).
3
4
1. Hanger bracket
2. Rear locking nut
9. Use the notches on the welded bracket to measure
the amount of adjustment. Each notch surface is
equivalent to 0.25 inch, while a single side is 0.125
inch (Figure 53). Adjust the height of the mower
deck to the desired height.
1
2
1. 0.25 inch
10. Stop the deck at the adjusted position and tighten the
rear locking nut on the hanger bracket to hold the
new position (Figure 52). Tighten the side locking
nut on the hanger bracket.
11. Continue leveling the deck by checking the
front-to-rear blade slope; refer to Adjusting the
Front-to-Rear Blade Slope.
37
1
2
G015324
Figure 52
3. Side locking nut, slotted
position.
4. Adjustment notches
G015325
Figure 53
2. 0.125 inch