Table of Contents
Advertisement
Figure 20
To go straight, apply equal pressure to both motion
control levers (Figure 20).
To turn, release the pressure on the motion control
lever toward the direction you want to turn.
To stop, push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height of Cut
1. Raise the height-of-cut lever to the transport
position, cutting height position 4.5 (also the
4-1/2 inch [115 mm]) (Figure 21).
G008953
1. Height-of-cut lever
2. Height-of-cut positions
2. To adjust the height of cut, pull upward and in the
lever then move it to the desired position.
Positioning the Seat
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 22).
1
1. Adjustment bolt
2. Move the seat to the desired position and tighten
the bolts.
20
3
1
2
G014476
Figure 21
3. 4.5 inch (115 mm),
Transport position
G014477
Figure 22
Hide quick links:
Advertisement
Table of Contents
