Toro SS 3200 Operator's Manual page 41

WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the machine without grass deflector,
discharge cover or grass collection system in place.
32 inch Decks
1. Locate items shown in Figure 61.
2
3
5
7
1
Figure 61
1. Mower deck
2. Grass deflector
3. Grass deflector bracket
4. Rod
2. Remove the nut (3/8 inch) from the rod under the
mower (Figure 61).
3. Slide the rod out of the short stand-off, spring, and
grass deflector (Figure 61). Remove the damaged
or worn grass deflector.
4. Replace the grass deflector (Figure 61).
5. Slide rod, straight end, through the rear grass
deflector bracket.
6. Place the spring on the rod, with end wires down,
and between the grass deflector brackets. Slide rod
through second grass deflector bracket (Figure 61).
7. Insert rod at front of grass deflector into short
stand-off on deck. Secure rear end of rod into the
mower with a nut (3/8 inch) (Figure 61).
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
4
6
G014636
5. Spring
6. Nut (3/8 inch)
7. Short stand-off
42 inch Decks
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1. Locate items shown in Figure 62.
3
2
1
1. Mower deck
2. Grass deflector
3. Grass deflector bracket
4. Rod
2. Remove the nut (3/8 inch) from the rod under the
mower (Figure 62).
3. Slide the rod out of the short stand-off, spring, and
grass deflector (Figure 62). Remove the damaged
or worn grass deflector.
4. Replace the grass deflector (Figure 62).
5. Slide rod, straight end, through the rear grass
deflector bracket.
6. Place the spring on the rod, with end wires down,
and between the grass deflector brackets. Slide rod
through second grass deflector bracket (Figure 62).
7. Insert rod at front of grass deflector into short
stand-off on deck. Secure rear end of rod into the
mower with a nut (3/8 inch) (Figure 62).
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
41
4
7
G005303
Figure 62
5. Spring
6. Nut (3/8 inch)
7. Short stand-off
5
6