TE 500 / TE 500 AVR breaker Operating controls and indicators 1 It is essential that the operating instructions Chuck are read before the power tool is operated Function selector switch for the first time. Control switch Control switch lock...
Modification of the power tool or tampering with its parts is not permissible. To avoid the risk of injury, use only genuine Hilti accessories and insert tools. Observe the information printed in the operating instructions concerning operation, care and maintenance.
Page 6
2.6 Lubrication Gearing and hammering mechanism with separate lubrication chambers 2.7 Active vibration reduction (only TE 500 AVR) The power tool is equipped with an AVR active vibration reduction system which reduces vibration significantly compared to power tools without active vibration reduction.
Option company remote and TPS K key Use the Hilti insert tools listed below. With these insert tools you will achieve higher performance and longer tool life as the power tool and insert tools have been optimized as a system.
Mains frequency 60 Hz 5.6 kg (12.35 lb) Weight of the TE 500 Weight of the TE 500 AVR 5.7 kg (12.57 lb) Dimensions (L x W x H) 471 mm (18.54 in) x 108 mm (4.25 in) x 243 mm (9.57 in)
Page 9
plugging in power tools that have the switch on conditions and the work to be performed. Use of invites accidents. the power tool for operations different from those intended could result in a hazardous situation. d) Remove any adjusting key or wrench before turning the power tool on.
Hilti Service Center. Under unfavorable circum- water. Allowing dust to get into your mouth, eyes, stances, dampness or dust adhering to the surface...
6.2 Unlocking the tool (theft protection system) 6.3 Use of extension cords and generators or transformers NOTE See section “Using the TPS theft protection system”. Please refer to section 2 “Description”. 7. Operation 7.2 Operation DANGER Always hold the power tool securely with both hands CAUTION on the grips provided.
2. Hold the TPS key or the TPS watch strap buckle shaped chisels can always be set to the optimum against the lock symbol. The power tool is un- working position. locked as soon as the yellow theft protection 7.2.2.1 Chisel position adjustment 6 indicator LED no longer lights.
To ensure that the power tool is always ready for use, it should be returned to Hilti for servicing in good time. Blinking red light See section “Troubleshooting”.
10. Disposal Most of the materials from which Hilti tools or machines are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old tools for recycling.