Installing The Polar Bike Mount; Installing The Polar Speed Sensor; Getting Going - Polar Electro Xtrainer Plus User Manual

INSTALLING THE POLAR BIKE MOUNT

1. 2.
Use
cable
ties to secure
the Bike Mount
snugly.

INSTALLING THE POLAR SPEED SENSOR

1. Check the front side of the right front fork to find a
suitable place for the speed sensor. The sensor should be
attached 40-50 cm / /1'4"-1'8" from the bike mounted XTrainer
Plus receiver. Note also that both the XTrainer Plus receiver
and the Speed Sensor should be mounted on the same side
of the bike.
1 2. Remove the cover paper
from the rubber pad and
attach the pad to the fork
blade in a suitable place.
3. Position the bracket of the
sensor on the rubber pad as shown.
Pass the cable ties through the mounting bracket
and loosely adjust the ties. Do not fully tighten yet.
4. Attach the magnet to one spoke. For details in installing
correctly, see page 49.
5. Fine tune the positioning of both the magnet and
the sensor so that the magnet passes the sensor
4
closely but doesn't touch it.
distance between the speed sensor and the
spoke magnet should be 5 mm / 0,2". Test the
sensor by checking that the sensor gives out a red
5
flash every time the magnet of the spinning wheel
passes the sensor. Note that to save battery
life this checking procedure does not continue whilst riding.
6. Once positioned correctly, tighten the cable ties
securely and cut off excess tie ends.
7. Secure the tightening screw with a coin.
If you are leaving your bike and concerned about
security, you may remove the sensor from the
bracket and take it with you. Simply loosen the
tightening screw with a coin.
8
3.
To attach, use
the wrist strap.
2
3
The maximum
7
6

GETTING GOING

1. Attach the Polar Coded Transmitter
to the elastic strap. Lock the buckle
firmly until you feel the "snap".
2. Wet the grooved electrode areas
on the backside of the Polar Coded
Transmitter. The key to flawless operation
is to wet the grooved electrode areas carefully.
3. Secure the strap around your chest.
Lock the other buckle.
4. Adjust the strap length to
fit snugly and comfortably.
5. Set the Polar Coded Transmitter
below the breasts. Check that the
grooved electrode areas are wet and
against your skin. Check also that the Polar
logo is in a central upright position. Wear the
Receiver as you would wear an ordinary watch.
6. When cycling, attach the
Receiver carefully on the
Polar Bike Mount as previously
instructed. (See Installing the
Polar Bike Mount.)
9