Summary of Contents for Metra Electronics 2004-2006 Chrysler Pacifica
Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-6506 APPLICATIONS 2004-2006 Chrysler Pacifica 99-6506 KIT FEATURES • DIN Head unit provision with pocket • ISO DIN Head unit provision with pocket KIT COMPONENTS A) Radio Housing B) ISO Brackets C) Trim Plate TOOLS REQUIRED: Phillips Screwdriver •...
99-6506 DASH DISASSEMBL Y 2004-2006 CHRYSLER PACIFICA Disconnect the negative battery terminal to prevent an accidental short circuit. Loosen (1) T-15 Torx screw from the front side of shift knob and pull up to remove. (Figure A) Unsnap floor console trim around the AUTOSTICK shifter.
99-6506 KIT ASSEMBL Y DIN HEAD UNIT PROVISION Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward. (Figure A) Slide the aftermarket head unit into the cage and secure. Snap the Trimplate into the Radio Housing. (Figure B) Note: When DIN mounting a radio a piece of plastic in the dash cavity may...
99-6506 KIT ASSEMBL Y ISO DIN HEAD UNIT PROVISION Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) Slide the head unit into the radio opening until the side clips engage. Snap the Trim Plate into the Radio Housing.
99-6506 FINAL ASSEMBL Y FINAL ASSEMBL Y 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.