Remote Control - Sony RDR-HXD870 Operating Instructions Manual

Display
The clock has stopped.
, Set the clock again (page 112).
, The clock stopped due to a power failure
that lasted for more than 1 hour. Reset the
clock (page 112).
The timer indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc into the recorder.
, The inserted DVD is protected (page 36).
The clock does not appear in the front
panel display when the recorder is turned
off.
, "Front Panel Display" is set to "Off" in the
"Options" setup (page 133).

Remote control

The remote does not function.
, Different command modes are set for the
recorder and remote. Set the same
command mode (page 134). The default
command mode setting for this recorder and
the supplied remote is DVD3. You can
check the current command mode in the
front panel display (page 134).
, The batteries are weak.
, The remote is too far from the recorder.
, The remote's manufacturer code returned to
the default setting when you replaced the
batteries. Reset the code (page 23).
, The remote is not pointed at the remote
sensor on the recorder.
Others
The recorder does not detect a USB device
connected to the recorder.
, Make sure that the USB device is securely
connected to the recorder (page 109).
, Check if the USB device or a cable is
damaged.
, Check if the USB device is on.
Display language on the screen switches
automatically.
, When "HDMI Control" is set to "On" in the
"HDMI Output" setup (page 133), the
display language on the screen
automatically switches, according to the
language setting of the connected TV, if
you change the language settings on your
TV, etc.
The recorder does not operate properly.
, Press down [/1 on the recorder for more
than five seconds until the recorder turns
off. Then, press [/1 again to turn on the
recorder.
, When static electricity, etc., causes the
recorder to operate abnormally, turn off the
recorder and wait until the clock appears in
the front panel display. Then, unplug the
recorder and after leaving it off for a while,
plug it in again.
The disc tray does not open after you press
Z (open/close).
, It may take a few seconds for the disc tray
to open after you have recorded or edited a
DVD. This is because the recorder is adding
disc data to the disc.
Any buttons do not function and "LOCKED"
appears in the front panel display.
, The recorder is locked. Cancel the Child
Lock (page 64, 91).
The disc tray does not open and
"TRAYLOCKED" appears in the front panel
display.
, Contact your Sony dealer or local
authorized Sony service facility.
"REPAIR" appears in the front panel
display.
, The recorder's repair function is activated
to repair the hard disk drive or disc. Leave
the recorder on until "REPAIR" disappears
from the front panel display. Some data
may be lost even if the repair function is
activated.
141
,continued