Resetting The Recorder; Notes About This Recorder - Sony RDR-HXD870 Operating Instructions Manual

"E01" appears in the front panel display.
, There is a problem in the HDD. Contact
your nearest Sony dealer. Note that contents
on the HDD may be erased when servicing
this unit.
"E02" appears in the front panel display.
, The HDD information is incorrect. You
cannot make a new recording to the HDD.
Format the HDD following the instructions
of "Format HDD." (page 111). Note that all
of the recorded contents on the HDD will be
erased. If this does not fix the problem,
contact your nearest Sony dealer.
"HDCP_ERR" appears in the front panel
display.
, The recorder is connected to an input device
that is not HDCP compliant. Connect the
equipment that is HDCP compliant
(page 17).
Disregard this error message if the output
picture is displayed correctly.
The Parental Lock does not work.
, Check the "D.TV Parental Lock" setting in
the "Parental Lock" setup (page 130).
Mechanical sounds are heard when the
recorder is off.
, While the recorder is updating the EPG
information, operational noises (such as the
internal fan) may be heard, even when the
power is off. This is not a malfunction.
, While the recorder is adjusting the clock for
the Auto Clock Set function, operational
noises may be heard, even when the power
is off. This is not a malfunction.
142

Resetting the Recorder

You can reset the recorder to all its factory
settings.
1
Make sure that the recorder is turned
on and remove the disc.
2
Hold down x (stop) on the recorder
and press [/1 on the recorder.
All settings are reset and the recorder
turns off.
Notes About This
Recorder
On operation
• If the recorder is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lenses inside the recorder. Should
this occur, the recorder may not operate
properly. In this case, if the recorder is on,
leave it on (if it is off, leave it off) for about
an hour until the moisture evaporates.
• When you move the recorder, take out any
discs and do not apply shock or vibration to
the hard disk drive to avoid damaging the
disc or hard disk drive (page 2).
On adjusting volume
Do not turn up the volume while listening to
a section with very low level inputs or no
audio signals. If you do, the speakers may be
damaged when a peak level section is played.
On cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent
such as alcohol or benzine.
On cleaning discs, disc/lens cleaners
Do not use cleaning discs or disc/lens
cleaners (including wet or spray types).
These may cause the recorder to
malfunction.