Making Hot Water - Nespresso D300 Instructions For Use Manual

Setting the cup filling
quantity
You can easily change or adjust the cup filling
quantity set in the factory.
Proceed as described under «Making espres-
so» up to «replace the capsule holder on the
capsule cage».
Now place the cup for which you wish to set
the filling quantity automatically under the
coffee outlet
Decide whether it is to be programmed by
means of the key
Press the appropriate key until ENOUGH
COFFEE? Appears on the display. Release
the key. As soon as the cup filling level has
been reached, press the key again and the
word READY appears on the display
Proceed in exactly the same way to adjust
the cup filling quantity, i.e.
You can reduce the filling quantities set in the
factory or those you have programmed you-
self by briefly pressing either of the keys
or before the automatic cutout occurs. This
will not affect the programmed settings.
Note : if a power failure occurs, the values set
in the factory and those programmed by you
are memorized.

Making hot water (13)

This machine enables you to prepare hot water
for tea, bouillon, etc.
Fill the water tank and connect the machine.
When READY appears on the display, place
a receptacle under the hot water nozzle
Turn the switch to the right on the machine
control box towards you to position
WATER appears on the display.
or the key
or
.
.
As soon as the desired quantity of water has
been obtained, return the switch to its initial
position
WARNING! The steam/hot water nozzle
is very hot
Use of steam (14-16)
Steam can be used to foam milk for cappuccino.
For this purpose your machine has a special foam
device which guarantees ideal results. The steam
can also be used to heat liquids. Proceed as follows.
Note : Before making steam, remove the used
capsule from the capsule holder to prevent the
coffee from drying and clogging the coffee out-
let opening.
Heating liquids (14,15) (such as cold milk)
Fill the water tank, start the machine with the
press the key . WAIT STEAM appears on
the display. The necessary operating tempera-
ture is reached when STEAM READY appears.
Lift the special foaming device about 3-5mm
by using the plastic handle
Direct the steam/hot water nozzle towards
the grid. Turn the knob slowly towards you in
position and allow the water in the noz-
zle to flow out into the drip tray
As soon as steam emerges from the nozzle,
pivot the latter and immerse it deeply in the
liquid to be heated but in such a way that
this liquid cannot penetrate into the foaming
device from above
Heat the liquid by effecting circular move-
ments from the bottom upwards. The duller
the noise of the steam the higher the liquid
temperature will be
Cappuccino foam (16)
Fill the water tank, start the machine with the
press the key . WAIT STEAM appears on
,
,