Programming The Machine - Nespresso D300 Instructions For Use Manual

Fill the water tank with fresh, cold water (1-3).
Place the empty capsule holder in the capsule
holder ring and turn from left to right. When
it is correctly inserted, the handle faces for-
wards or slightly to the right (4)
Place a sufficiently large receptacle under the
capsule holder and another under the
steam/hot water nozzle (5)
to start the machine (6). The
Press key
words FILL WATER appear on the display
Turn the switch to position
emerges from the steam/hot water nozzle and
the word WATER appears on the display (7)
Allow around 1/2 a litre of water to flow.
Then reset the switch to position «0». READY
appears on the display
To clean the coffee system, now press the key
. LARGE appears on the display (8). This
allows the quantity of water preset in the facto-
ry to flow through the coffee system. Repeat
this operation five times.
Programming the
machine (9)
Access to the programming mode
To access the programming mode, the machine
must be connected to the power supply.
Press the key /P (approx.3sec) until TIME
appears on the display.
To quite the programming mode, press the key
/P until the message READY appears on the
display, or if the machine has not yet warmed
up, WAIT.
Selection of the different programming points
Press the key /P to select the different pro-
gramming points. As soon as the desired pro-
gramming point appears on the display, press
the key / «+» or the key
; water now
/ «-» to access
the corresponding programming point. You can
modify the setting of the programming points by
pressing the key / «+» or the key
Setting the TIME
When the word TIME appears on the display, the
display changes to --.--. Now press the key
/ «+» or / «-» and the time display flashes.
You can now adjust the time with the key
or / «-». Confirm the entry by pressing the key
/P. The minutes display now flashes. Set the
exact time by pressing the key
Confirm the entry by pressing the key
Note: --.-- Function deactivated
00:00 Midnight
This function is not activated in the factory. If the
machine is disconnected from the power supply,
the time will have to be reprogrammed.
AUTO ON setting
When this programming point is activated, your
machine starts automatically. This message only
functions correctly if you have first set the right
time. Press the key
AUTO ON appears on the display.
Now press the key
The time display flashes. You can now set the
time using the keys
Confirm the entry by pressing the key
The minutes display now flashes. Set the exact
time by pressing the key
Confirm the entry again by pressing the key
Note: --.-- Function deactivated
00:00 Midnight
This function is not activated in the factory. If the
machine is disconnected from the power supply,
the time will have to be reprogrammed.
AUTO OFF setting
When this programming point is activated, your
machine stops automatically. This programming
point functions, regardless of whether you have
set the time.
/ «-».
/ «+»
/«+» or /«-».
/ P again.
/ P until the message
/ «+» or «-».
/ «+» or / «-».
/ P.
/ «+» or / «-».
/P.