Safety Instructions; Preparing The Machine - Nespresso D300 Instructions For Use Manual

SAFETY
INSTRUCTIONS
Read these instructions carefully
before using your NESPRESSO
machine.
Do not plug the machine into anything other
than a grounded electrical socket. Verify that
the voltage indicated on the technical specifi-
cations plate on the bottom of the unit corre-
sponds to your electrical installation.
Do not place your NESPRESSO machine on a
hot surface (an electrical heating plate for
example) or near a flame.
Do not remove the capsule holder from the
spout ring while the machine is functioning
since the extraction of coffee is done under
high pressure.
Do not use the machine without the drip tray
and grill in place.
Remove the plug when cleaning your machine.
Ensure that the electrical cord does not come
into contact with sharp or hot objects. Do not
disconnect the electrical plug by pulling on
the cord.
Avoid touching the electrical cord as well as
any other part which may become hot during
the use of the machine (steam nozzle, chrome
portion of capsule holder).
Never plunge the machine in water.
Keep the machine and the electrical cord out
of children's reach.
For descaling, adhere to the directions which
follow.
Do not use the machine if it is damaged or if
the cord is in bad condition.
The cord or any other defective element must
be replaced exclusively by NESPRESSO Club.
Under no circumstances should you open the
machine yourself.
Accessories
The machine is delivered with a range of
accessories:
1 hexagonal key to remove the capsule cage,
1 cleaning tool,
For further information concerning the different
varieties of NESPRESSO coffee and to order cap-
sules, contact your NESPRESSO Club.

Preparing the machine (1-3)

Remove the water tank by lifting it out by its
lid (1) and fill it with water (2).
Maximum capacity : 1.2 l.
Applying light pressure to facilitate the open-
ing of the bottom valve, put the water tank
back into place (3) and close the lid (4).
Since water quality is essential to a good
NESPRESSO, we recommend that you:
Use fresh tap water.
Change the water in the tank daily.
Clean the tank at least once a week.
We advise you not to use distilled or mineral water.
Start Up (4-8)
Note : the display language is set to French in
the factory. To select a different language, follow
the «Programming» procedure described on next
page to make the change.
Before using the machine for the first time, we
advise you to clean it as follows:
Connect the power plug