Operation; Switching The Workstation On; Switching Off The Workstation - Fujitsu Siemens Computers CELSIUS M Operating Manual

Operation

Switching the workstation on

► If necessary, switch the monitor on (see the operating manual for the monitor).
► Switch on the workstation with the main power switch on the rear of the workstation (if
present).
► Press the ON/OFF switch on the front of the workstation.
The corresponding indication appears on the LCD (see section "Indicators on the workstation") or
the operating indicator lights green, the workstation starts up.

Switching off the workstation

► Shut down the operating system properly. For Windows: select Shut Down from the Start menu.
► If the workstation operating system does not switch off automatically, use the ON/OFF switch
to switch off the workstation when requested.
If the workstation is ready-to-use, the workstation consumes very little power.
Switch off the workstation at the main switch (if present). The workstation no longer uses any power.
The main switch and the ON/OFF switch do not disconnect the workstation from the
!
mains voltage. To completely disconnect the mains voltage, remove the power plug from
the socket.
► If necessary, switch the monitor off (see the operating manual for the monitor).
Placing a workstation (with soft power off function) in a ready-to-operate state by means of
software
With the soft power off function the workstation automatically switches off (standby) or switches into
the energy-saving mode after the operating system is shut down. Requirements: Your system must
support switching off with software and this functionality must be enabled in BIOS Setup. The soft
power off software may also need to be installed on Windows NT systems.
You can also switch your workstation into the standby mode via the DeskView software with the
DeskOff programme.
A26361-K665-Z125-1-7619, Edition 1
19