Registering A Unit - Panasonic KX-TG6711HK Operating Instructions Manual

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
#130
2
Base unit:
Press and hold M
(No registration tone)
R If all registered handsets start ringing,
press M N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3
Handset:
a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a
R If you forget your PIN, contact an
authorised service centre.
R When the handset has been registered
successfully,
Note:
R While registering, "Base in
registering" is displayed on all
registered handsets.
N for about 5 seconds.
is displayed.
R When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
#131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a
3
MbN: "Yes" a
R A confirmation tone sounds.
R The handset does not beep when
cancelling its own registration.
4
M N
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
#138
2
MbN: Select the desired setting. a
a M N
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
Programming
is displayed.
27