Table of Contents
Advertisement
9
Slide the system board toward the front of the case, then up and out of
the case. The system board standoffs slide out of the keyhole slots.
10
Slide the new system board into the keyhole slots and lock it into place
with the thumbscrew.
Important
11
Reconnect the power and data cables using your notes from Step 4. See
the system board documentation for further instructions.
12
Reinstall the add-in cards by following the instructions in
replacing add-in cards" on page
13
Close the case by following the instructions in
page
127.
The new system board must have special standoffs
(pem studs) mounted on the bottom of the board. If
necessary, use the standoffs from the original system
board.
136.
www.gateway.com
Gateway Micro Tower Case
"Adding or
"Closing the case" on
143
Advertisement
Table of Contents
Troubleshooting
