Table of Contents
Advertisement
7
While pulling outward on the hard drive bracket, lift the old hard drive
out of the hard drive cage.
8
Set any jumpers on the new drive to match the old drive. See the drive
documentation for further instructions.
9
While pulling outward on the hard drive bracket, insert the edge of the
new hard drive into the drive bracket, pivot the new drive into the bracket,
then pivot the hard drive cage toward the drive cage assembly.
10
Reconnect the drive cables using your notes from Step 5. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). See the drive documentation for further instructions.
11
Close the case by following the instructions in
page
127.
www.gateway.com
Gateway Micro Tower Case
"Closing the case" on
135
Advertisement
Table of Contents
Troubleshooting
