Advertisement
10
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3) using KEY (3a) supplied.
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks.
if necessary.
11
SERVICE
To change direction of handle:
Turn valve to OFF position
Remove SET SCREW (6) with 5/64" Hex Wrench.
Pull HANDLE (1) "UP" firmly to release from ADAPTER (2).
Remove ADAPTER SCREW (3) from ADAPTOR (2).
Pull off ADAPTER (2).
Remove SPRING CLIP (4). Lift STOP WASHER (5),
turn 90˚ and replace. Replace SPRING CLIP (4).
Replace ADAPTER (2) and ADAPTER SCREW (3).
Find correct position of HANDLE ASSEMBLY (1)
by adjusting male teeth on ADAPTER (2) to female
teeth in HANDLE ASSEMBLY (1).
Push HANDLE (1) down onto ADAPTER (2).Tighten
SET SCREW (6) with 5/64" Hex Wrench.
12
OPTIONAL SPOUT LOCKING FEATURE
The Pull-Out SPOUT (1) can be locked to the SPOUT BASE (2) if desired.
To secure the Pull-Out SPOUT (1) to SPOUT BASE (2), tighten the SET
SCREW (3) clockwise in the back of the SPOUT BASE (2) with a 2.5mm
hex wrench.
13
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
Tighten
4
4
4
1
5
WASTE
OUTLET
2
1
5/64" HEX
6
WRENCH
90˚
5
1
3
2.5mm HEX
WRENCH
1
OFF
3
3a
2
"P" TRAP
3
2
2
M 9 6 8 5 9 9 R ev. 1. 2
Advertisement
