Advertisement
7
ATTACH CABLE CONNECTOR
Thread CABLE CONNECTOR (1) clockwise
onto DRAIN BODY CONNECTION (2) and
hand tighten. Fig. A.
Your new POP-UP DRAIN installation is
now complete. Fig. B.
Note: Tailpeice on pop-up drain is 1-1/4" O.D.
Fig. B.
8
CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
closes.
Note: If STOPPER (2) does not open and close properly then refer
to the "troubleshooting section" of these instructions.
9
SPOUT, WATER SUPPLY AND WASTE CONNECTIONS
Fig. A. From under mounting surface connnect FLEXIBLE INLET
TUBE (1) to HOSE END (2) and tighten with wrenches.
Attach WEIGHTS (3) to HOSE (4) at bottom of loop in Hose (4)
as shown.
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
Fig. B. Connect water supply to FAUCET with 1/2" IPS FLEXIBLE
SUPPLIES (5) or 3/8" O.D. BULL-NOSE RISERS (6).
Use adjustable wrench to tighten connections. Do not over tighten.
Be careful not to kink copper supply when bending. Use tubing
cutter to cut to proper length.
Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to waste outlet.
Fig. A
Fig. A.
1/2" PIPE
THREAD
FLEXIBLE
SUPPLIES
1
2
3
4
3
Fig. B.
1
2
2
Fig. B
5
3/8" COMPRESSION
CONNECTION
HOT
1-1/4" O.D.
1
COUPLING
NUT
6
3/8 O.D.
BULL-NOSE
RISERS
COMPRESSION
NUT
FERRULE
COLD
M 9 6 8 5 9 9 R ev. 1. 2
Advertisement
