American Standard Portsmouth Installation Instructions Manual

Portsmouth
Pressure Balancing
Bath and Shower Trim Kit
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
For use with shower heads rated at 4.9 L/min (1.3 gpm) or higher.
RECOMMENDED TOOLS
Plumbers' Putty
or Caulking
ROUGHING-IN DIMENSIONS
• To assure proper positioning in relation to wall.
Note roughing-in dimensions.
FINISHED WALL
3-3/4" REF.
(95 mm)
7-1/2" REF.
(191 mm)
74" FOR HEAD CLEARANCE
(188 cm)
18" OPTIONAL
(45,7 cm)
(130 mm) REF.
BOTTOM OF TUB
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2020
INSTALLATION
INSTRUCTIONS
®
Teflon Tape Flat Blade Screwdriver
1-5/8" TO 3"
(41mm TO 76mm)
1/2" NPT
(12,7 mm) NPT
OPTIONAL TO
FINISHED FLOOR
7-1/4" USUALLY BETWEEN
(184 mm)
65'' AND 78''
2-3/4" MAX. (69 mm)
1-3/4" MIN. (45 mm)
7-5/8" DIÁM.
(195 mm)
1-1/2" REF.
(38 mm) REF.
1/2" COPPER
5-1/8" REF.
4" (102 mm)
TOP OF TUB RIM
TU41550X
TU42050X
Phillips Screwdriver
1 1
CARTRIDGE INSTALLATION
• Remove PLASTER GUARD (6)
(Keep it installed for thin wall Installation).
• Remove BONNET NUT (1) by unthreading it
Counter clockwise. Remove test CAP (2).
• Remove PROTECTIVE HOUSING (3) from
CARTRIDGE (4). Install with "UP" text on top.
• Reinstall BONNET NUT (1) onto VALVE BODY (5)
and tighten firmly with 12 Nm or 9 lbs/ft.
6-3/8"
(163 mm)
NOTE: Specified tightening torque
of BONNET NUT (1) is critical to
assure sealing function.
- 1 -
H
C
O ff
TU41550X
Adjustable Wrench
5
1
3
4
2
H
C
O ff
TU42050X
Channel Locks
6
M965927 Rev. 1.1 (3/20)