Changing The Tv Format Setting; Resetting The Main Unit; Specifications - Pioneer VSX-819H-k Operating Instructions Manual

Audio/video multi-channel receiver
Hide thumbs Also See for VSX-819H-k:
Table of Contents

Advertisement

Additional information

Changing the TV format setting

If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
1
Switch the receiver into standby.
2
While holding down the 'TUNE +' button,
press and hold the  STANDBY/ON button
for about two seconds.
The display shows the new setting (PAL or
NTSC).

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the BAND button,
press and hold the  STANDBY/ON button
for about two seconds.
3
When you see RESET? appear in the
display, press 'AUTO SURROUND/STREAM
DIRECT'.
OK? shows in the display.
4
Press 'STEREO/A.L.C.' to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.

Specifications

Audio section
FTC power output
. . . . . . . . . . . . . . . . . . . . . . . . . . . 65 W + 65 W
(STEREO, 20 Hz to 20 kHz, 8 Ω, 0.2 %)
Rated power output (Front, Center, Surround)
. . . . . . . . 125 W per channel (1 kHz, 6 Ω, 1 %)
Maximum power output (Front, Center, Surround)
. . . . . . . 150 W per channel (1 kHz, 6 Ω, 10 %)
Total Harmonic Distortion
. . . . . . 0.06 % (20 Hz to 20 kHz, 8 Ω, 85 W/ch)
Guaranteed speaker impedance
FRONT : A, B . . . . . . . . . . . . . . . . . . 6 Ω to 16 Ω
FRONT : A+B . . . . . . . . . . . . . . . . 12 Ω to 16 Ω
SURROUND, CENTER . . . . . . . . . . 6 Ω to 16 Ω
Input (Sensitivity/Impedance)
LINE . . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 kΩ
Output (Level/Impedance)
REC . . . . . . . . . . . . . . . . . . . . . . . 200 mV/330 Ω
ZONE 2 . . . . . . . . . . . . . . . . . . . . . 200 mV/1 kΩ
Signal-to-Noise Ratio
(IHF, short circuited, A network)
LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .98 dB
Tuner Section
FM Frequency Range . . . . 87.5 MHz to 108 MHz
Antenna Input . . . . . . . . . . . . . 75 Ω unbalanced
AM Frequency Range
9 kHz step . . . . . . . . . . . . .531 kHz to 1602 kHz
10 kHz step . . . . . . . . . . . .530 kHz to 1700 kHz
Antenna . . . . . . . . . . . . . . . . . . . . . . Loop antenna
Video Section
Signal level
Composite . . . . . . . . . . . . . . . . . . 1 Vp-p (75
Component Video. . . . . . . . . Y: 1.0 Vp-p (75
Corresponding maximum resolution
Component Video. . . . . . . . . . . .1080p (1125p)
Digital I/O
HDMI terminal . . . . . . . . . . . . . . 19-pin (Not DVI)
HDMI output type . . . . . . . . . . . . . . . 5 V, 100 mA
iPod terminal. . . . . . . USB + Video (Composite)
Ω
)
Ω
)
Ω
PB, PR: 0.7 Vp-p (75
)
12
69
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents