Dw90.2 - Asko DW90 Series Service Manual

Service manual DW90
Service menu
DW90.2 cont.
T8 T1
Menu step/Turn/Push
Variant
PROG
START
Region
PROG
START
Fan sequence
PROG
START
TDE & HWC
PROG
START
Super rinse
PROG
START
Total reset
PROG
START
D1, I5,
LCD1 D2, D3
LCD Comments/instructions
U:1 Variant 1, default setting (Temperature, Drying)
U:2 Variant 2 (Temperature, Drying, Delayed start)
U:3 Variant 3 (Temperature, Drying, Delayed start, Time program)
U:4 Variant 4 (Temperature, Drying, Delayed start, Time saver)
EU Region Europe (as well as China and Japan), default setting
US Region USA (as well as Taiwan)
AU Region Australia
Y:0 No fan sequence during program. Dries the load.
Fan works in sequence during the wash cycle, not in normal program,
Y:1
default setting
Fan works in sequence during the wash cycle, even during normal
Y:2
program
Turbo Drying Express and Heating Water Circuit off, default
A:0
setting
A:1 Turbo Drying Express on.
Heating Water Circuit on. Uses hot water system as far
A:2 as possible, aided by electrical energy, to minimize energy
consumption.
S:0 Super rinse off, default setting
S:1 Super rinse on. Adds two extra rinses.
r:0 No total reset next time T2 is pressed, default setting
Total reset next time T2 is pressed. Should be done after replacing
the control unit to reset all the sensors.
r:1
(Setting for TDE or HWC reverts to default off and has to be set again
after a total reset.)
T3 T4 T5
Variant 1
Variant 2
Variant 3
Variant 4
T6 T7 T2
31