Service Menu Dw90.2 - Asko DW90 Series Service Manual

Service manual DW90
Service menu
DW90.2
T8 T1
Opening the service menu
Open the door, put the machine in standby mode by pressing the main power switch (T8).
Activate the machine again by pressing the button (T8), press and hold the program selector
(T1) and (T2) for 5 sec. LCD shows:
PROG + START
error message is shown, F:XX. All error messages are erased by a total reset. It is only possible
to leave the service menu by pressing the button (T2). It is not possible to leave the service
menu by using the main power switch (T8).
START Press the button (T2) to navigate the menu system step by step.
Press the button (T1) to scroll between settings. Press (T2) to save the setting and continue to
PROG
the next menu step.
Press (T2) at the last step of the menu to close the service menu and save the most recent
START
settings.
Menu step/Turn/Push
START
Diagnostics
PROG
START
Water intake
PROG
START
30
D1, I5,
LCD1 D2, D3
LCD Comments/instructions
d:01 Mixer valve and inlet valve on (1 second delay between mixer
valve and inlet valve)
d:02 Inlet valve and mixer valve off for 1 second then inlet valve on
d:03 Salt valve on
d:04 Combi dispenser on
d:05 Circulation pump on and the spray arm diverter (if available) shall
alternate between positions 1 and 3 every 30 seconds
d:06 Circulation pump and heater on - max. 75°C (167°F)
Fan and Wax motor and Turbo Drying Express and Heating
d:07
Water Circuit on
d:08 Drain pump on
d:00 No components on
P:0 Normal water intake volume, default setting
P:5 Water intake volume increases by +5%
P:10 Water intake volume increases by +10%
P:15 Water intake volume increases by +15%
L:0 Time, flow meter switched off, intake time:
pulse value x 0.068 [s]
L:5 Time-controlled water intake increases by +5%
L:10 Time-controlled water intake increases by +10%
L:15 Time-controlled water intake increases by +15%
T3 T4 T5
Variant 1
Variant 2
Variant 3
Variant 4
. When the service menu is opened the most recent
T6 T7 T2