Asko DW90 Series Service Manual page 21

Service manual DW90
Programs and control unit
Program flow description
Presented below is the Quick program, no options selected (DW90.1).
Step Component
Main wash
1 Drain process
2 Inlet process
3 Circ. pump
4 Pause
5 Circ. pump
6 Pause
If ECO is Circ.pump
set
Drain process
Inlet process
7 Circ. pump + Combi dispenser
8 Circ. pump + Element
9 Circ. pump
10 Cleaning cycle for container
11 Drain process
1:st rinse
12 Inlet process
13 Circ. pump
14 Pause
15 Circ. pump
16 Drain process
2:nd rinse
17 Inlet process
18 Circ. pump
19 Cleaning cycle for container
20 Drain process
3:rd rinse
21 Inlet process
22 Circ. pump
23 Circ. pump + Element
24 Circ. pump + Combi dispenser
25 Drain process
Drying
26 Fan
27 Signal
Explanations
Cleaning Cleaning cycle for container
process
*
Inlet Inlet process
process
**
Drain Drain process
process
***
Time Comment
6 sec 12-16 sec when restarting or if an earlier program was interrupted
255 sec Maximum time. Inlet time is controlled by a flow meter**
3 sec
30 sec If water temperature is >30°C ECO program starts (DW90.1)
30 sec
5 sec
120 sec
120 sec Maximum time. Time is controlled by level sensor***
255 sec Maximum time. Inlet time is controlled by a flow meter**
10 sec
60°C If ECO 30°C
30 sec
90 sec Maximum time 90 sec. Minimum time 76 sec*
120 sec Maximum time. Time is controlled by level sensor***
255 sec Maximum time. Inlet time is controlled by a flow meter**
3 sec
5 sec
3 sec
120 sec Maximum time. Time is controlled by level sensor***
255 sec Maximum time. Inlet time is controlled by a flow meter**
150 sec
90 sec Maximum time 90 sec. Minimum time 76 sec*
120 sec Maximum time. Time is controlled by level sensor***
255 sec Maximum time. Inlet time is controlled by a flow meter**
60 sec
60°C
10 sec Pulses (varies depending on the setting of rinse aid)
120 sec Maximum time. Time is controlled by level sensor***
480 sec
4 sec If signal is selected
90 sec The circ. pump stops and the drain pump runs for 2 sec. The circ.
pump runs for 3 sec. and then rests for 5 sec. In total this is repeated
eight times, but the fifth time the circ. pump is resting for 8 sec instead
of 5 sec, when spray arm diverter is switching to the upper spray arm.
255 sec A flow meter signals the flow in pulses. The control unit (CU)
determines how many pulses to be calculated for each inlet. If not 80
pulses has been reached within 60 sec or a specific number of pulses
is not reached within 255 sec, the program will be interrupted.
120 sec The drain pump starts and pumps out until the level sensor reaches
a specified value. After that, the drain pump continues for additional
10 sec. The total time depends on how long it takes to reach the
specified value from the level sensor. If the specified value is not
reached within 120 sec, the program will be interrupted.
21