Retaining The Recovery Key/Password; Enabling The Trusted Platform Module - HP ProLiant DL320e Gen8 User Manual

Install the TPM security rivet by pressing the rivet firmly into the system board.
6.
Install the access panel (on page 19).
7.
Do one of the following:
8.
Slide the server into the rack.
o
Install the server into the rack
o
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server (on page 16).
11.

Retaining the recovery key/password

The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
•
Do not save the recovery key/password on the encrypted hard drive.

Enabling the Trusted Platform Module

When prompted during the start-up sequence, access RBSU by pressing the F9 key.
1.
From the Main Menu, select Server Security.
2.
From the Server Security Menu, select Trusted Platform Module.
3.
From the Trusted Platform Module Menu, select TPM Functionality.
4.
Select Enable, and then press the Enter key to modify the TPM Functionality setting.
5.
("Installing the server into the rack" on page 27).
Hardware options installation 52