Install The Access Panel; Remove The Air Baffle - HP ProLiant DL320e Gen8 User Manual

Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 16).
o
Remove the server from the rack (on page 17).
o
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
4.
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.

Install the access panel

Place the access panel on top of the server with the locking latch open. Allow the panel to extend past
1.
the rear of the server by approximately 1.25 cm (0.5 inch).
Press the locking latch. The access panel slides to a closed position.
2.
Use a T-15 Torx screwdriver to tighten the security screw on the locking latch.
3.

Remove the air baffle

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 16).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 16).
o
Remove the server from the rack (on page 17).
o
Remove the access panel (on page 18).
4.
For proper cooling, do not operate the server without the access panel, baffles,
Operations 19