Listen To The Radio; Manual Tuning; Auto Scan Stations; Direct Key-In Frequency - Tecsun PL-310 Operation Manual

Turn LW on/off
Turn off the radio. Press and hold the [MW/LW] button until
" " or " " appears in the display，If "
in the display, which means LW is turned off.
Turn off the "Bi" sound
Press and hold the [ ] button until "
appears in the display; If "
which means "Bi" sound is turned off.
Turn on / off intelligent lighting function
This radio bears the intelligent lighting function which back-
light would automatic be turned on for 3 seconds during
tuning or any key to be pressed.
Press & hold the numeric key "
being displayed and means this intelligent lighting function
is off. By pressing & hold the numeric key "
symbol " " is displayed and means the intelligent lighting
function is on now.
Special note: After shutting off the intelligent lighting
function, the [LIGHT/SNOOZE] key is still workable for
turning on or off the backlight.
Turning on / off the charging function
Press & hold [ ] key , symbol of "
be shown and means rechargeable batteries to be used for
starting the charging. Press & hold [
" " & " " to be lost on screen and means
alkaline batteries to be used and charging function to be off.
Special note: This radio is default to use alkaline batteries
for supplying power. In case of using rechargeable batteries,
you should switch radio to the status of rechargeable
batteries being used. The correct power capacity of
rechargeable batteries would be shown.
20
" appears
" or " "
" appears in the display,
", then symbol " "
5
" again,
5
" & " " to
] key, symbol of

LISTEN TO THE RADIO

Short press [POWER] button to turn on your radio, and
select your band by short press on [FM]、[MW/LW]、SW
[ ] or [ ] button. In case of receiving FM/ SW, telescopic
antenna should be pulled out as long as possible. Now, turn
in your favorite station with one of the following methods:
Method 1: Manual tuning
Rotate the [TUNING] knob to select your station.
FAST/SLOW tuning is shown in the chart below for each band.
step slow tuning mode
band
turning step
FM 0.01 MHz
MW 1kHz
LW 1 kHz
SW 1 kHz
Method 2: Auto scan stations
1. Short press [SCAN MODE] button with a "BB" sound.
2. Long press [SCAN MODE] button with a "B" sound to
activate the Auto-scanning function.
Auto search will stop on each
available station for 3 seconds
before it goes on searching for
the next available station.
3. To stop auto search function,
simply press any button, except
[M] button.
Note: When the radio search & stop to a station, just press
[M] button once to store it.
Method 3:

Direct key-in frequency

Use the numeric keypad to enter the frequency directly.
Note: No need to enter decimal point for FM Band when
input the frequency numbers. For example, FM 89.0 MHz,
just key in 8 9 0 .
Fast tuning mode
turning step
0.1 MHz
9 /10kHz
9 kHz
5 kHz
Frequency
flashing
changing
Timer
SLEEP
Auto-scan with pre-listening
9