Roland Fantom-X User Manual page 9

To learn about editing patch tones, see the Workshop series booklet The
Sounds of the Fantom-X.
To select the desired output, start by setting the Patch Out
Assign parameter. This parameter allows you to use a single
common output setting for all of the patch's tones, or to set
the routing of each tone individually. To:
• use the same output routing for all tones—set Patch Out
Assign to MFX, A, B, 1, 2, 3 or 4.
• set each tone's output individually—set Patch Out Assign
to Tone, and set each tone's Tone Out Assign parameter as
desired.
When you choose MFX as an output setting when programming a patch,
you're sending your signal to MFX 1.
Set each tone's Tone Out Level parameter to set its volume as
it travels to the selected output destination. You can also set
the volume of the tone as it goes to the Fantom-X chorus and
reverb. This is called its "send level. " To set a tone's chorus and
reverb send level when its output is:
• MFX—set the parameters in its Send Level (Output=MFX)
area as desired.
• A or B—set the parameters in its Send Level (Output= non
MFX) area as desired.
The Fantom-X ignores irrelevant parameters. For example, the non-MFX
send level for a tone is ignored if the tone's output is set to MFX.
Effect Routing in Rhythm Set Programming
Select the desired rhythm set and press PATCH EDIT. Press F2
(↓) repeatedly until the Output tab is selected.
Set the rhythm set's Rhythm Out Assign parameter, highlighted
in blue above. This parameter allows you to use a single
common output setting for all of the rhythm set's drum keys,
or to set the routing of each key individually.
In a drum set, each drum key plays up to four sound waves. When editing
a rhythm set, the word "tone" refers to a drum key. While each drum key
can have its own output destination, all of the key's waves share the same
output setting.
To:
• use the same output routing for all drum keys—set Rhythm
Out Assign to MFX, A, B, 1, 2, 3 or 4.
• set each drum key's output individually—set Rhythm Out
Assign to Tone, and set each drum key's Tone Out Assign
parameter as desired.
When you choose MFX as an output setting when programming a rhythm
set, you're sending your signal to MFX 2.
The currently
selected drum
key is circled
here in red.
9