Configure The Alarm Settings [Alarm] - Panasonic WV-NF302 Setup Instructions

Configure the alarm settings [Alarm]

The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, the alarm
occurrence notification, and the VMD area settings can be configured on this page.
The "Alarm" page has 3 tabs; the [Alarm] tab, the [VMD area] tab and the [Notification] tab.
The terminal alarms indicate the EXT I/Os respectively ( Installation guide).
Configure the settings relating to the alarm [Alarm]
Click the [Alarm] tab on the "Alarm" page. ( pages 4 and 5: How to display/operate the setup menu)
Refer to pages 32 and 34 for further information about the settings relating to the alarm image and the alarm output
terminal.
I Alarm
The settings relating to the alarm can be configured in this section.
[Terminal alarm]
Determine whether or not to use the terminal alarm by
selecting "On" or "Off".
On: Uses alarm.
Off: Does not use alarm.
Default: Off
[VMD alarm]
When the [VMD >>] button is clicked, the [VMD] tab
page ( page 35) will be displayed.
[Command alarm]
• Command alarm
Determine whether or not to use the command alarm by
selecting "On" or "Off".
The command alarm is the function that provides notifi-
cation of a Panasonic protocol alarm from the other
cameras. When "On" is selected, alarm actions will be
performed between multiple cameras.
Default: Off
• Originating port number
Select a port number to be used to receive the com-
mand alarm.
Available port number: 1 - 65535
Default: 8181
31