Configure The Settings Relating To Images And Audio [Image/Audio] - Panasonic WV-NF302 Setup Instructions

Configure the settings relating to images and audio
[Image/Audio]
The settings relating to JPEG/MPEG-4 images such as the settings of image quality, privacy zone, audio, etc. can
be configured on this page.
The "Image/Audio" page has 3 tabs; the [JPEG/MPEG-4] tab, the [Image/Privacy] tab and the [Audio] tab.
Configure the settings relating to JPEG/MPEG-4 images [JPEG/MPEG-4]
Click the [JPEG/MPEG-4] tab on the "Image/Audio" page. ( pages 4 and 5: How to display/operate the setup
menu)
I JPEG
Configure the settings such as "Refresh interval (JPEG)*", "Image capture size" and "Image quality" on this section.
Refer to page 21 for further information about the settings relating to MPEG-4 images.
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image
from the following.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps/2 fps/3 fps/5 fps/
6 fps */10 fps */15 fps */30 fps *
Default: 5 fps
Note:
When "On" is selected for "MPEG-4 transmission",
the refresh interval may be longer than the set value
when any value with an asterisk (*) on the right is
selected.
20
[Image capture size]
Select "QVGA", "VGA" or "1 280 x 960" for the image
capture size of JPEG images.
Default: VGA
[Image quality]
Select image quality of JPEG images from the following.
0 Super fine/1 Fine/2/3/4/5 Normal/6/7/8/9 Low
Default: 5 Normal