Troubleshooting - Panasonic WV-NF302 Setup Instructions

Troubleshooting

Before asking for repairs, check the symptoms on the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution or if the problem is not
described below.
Symptom
Cannot access from the web
browser.
Cause/solution
• Is the LAN cable (category 5) firmly connected to the
network connector of the camera?
• Is the link LED beside the SD memory card slot of the
camera lit?
When it is not lit, connection to a LAN may not be
established or a network may be not working correctly.
Check if the cables have any contact failure or if the
wiring is correct or not.
• Is the power of the camera on?
Check if the power of the camera is turned on.
• Are the set IP addresses valid?
• Are you accessing the wrong IP address?
Check the connection as follows:
With the Windows command prompt,
> ping "IP address of the camera"
When the WV-NF302 replies, the camera is functioning
normally.
If not, proceed either of the following.
• Reboot the camera and change the IP address by
using the Panasonic IP setup software within 20
minutes after the reboot.
• Reboot the camera with use of the [INITIAL SET]
button on the camera. The camera will be initialized
and the IP address will return to the default setting
"192.168.0.10".
After the camera is initialized, access the camera
and set the IP address again. (When the camera is
initialized, all the settings of the camera previously
configured on the setup menus will be initialized.)
Reference
pages
Installation
Guide
Installation
Guide
Installation
Guide
45
–
Installation
Guide
61