Standard Horizon Matrix GX2000 Owner's Manual page 7

DESKTOP/OVERHEAD MOUNTING THE RADIO
The supplied universal mounting bracket allows desktop or overhead mounting.
Use a 13/64" (5.2-mm) bit to drill the holes to a surface which is more 0.4 inch
(10 mm) thick and can support more than 3.3 lbs (1.5 kg) and secure the
bracket with the supplied screws, spring washers, flat washers, and nuts.
D
ESKTOP
The optional MMB-84 Flush-Mount Bracket allows flush mounting the radio to
your vessel.
1. Use the supplied template to mark the location where the rectangular hole
is to be cut. Confirm the space behind the dash or panel is deep enough to
accommodate the transceiver (at least 6.7 inches or 17 cm deep).
There should be at least 1/2
inch (1.3 cm) between the
transceiver's heatsink and any
wiring, cables or structures.
2. Cut out the rectangular hole
and insert the transceiver.
3. Fasten the optional MMB-84
brackets to the sides of the
transceiver with the lock
washer nut combination; so that the mounting screw base faces the mount-
ing surface.
4. Turn the adjusting screw to adjust the tension so that the transceiver is
tight against the mounting surface.
GX2000/GX2100
M
OUNTING
FLUSH MOUNTING THE RADIO
O
VERHEAD
Bracket
Lock-washer nut combination
M
OUNTING
Adjusting Screw
Page 7