10.10.3 Memory Scanning ( M-SCAN )
1. Adjust the SQL knob until background noise disappears.
2. Press the one of the soft key momentarily, then press the [ SCAN ] key. "M-
SCAN" appears on the display. Scanning will proceed from the lowest to
the highest programmed channel number and Pre-
set channel (descrived in the next chapter) and will
stop on a channel when a transmission is received.
3. The channel number will blink during reception.
4. To stop scanning, press the [ 16/9 ] or [ CLR ( WX )] key.
10.10.4 Priority Scanning ( P-SCAN )
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from Channel 16 by the Radio Setup
Mode, refer to section "12.17 PRIORITY CHANNEL".
1. Adjust the SQL knob until background noise disappears.
2. Press the one of the soft key momentarily, then press
the [ SCAN ] key. "P-SCAN
Scanning will proceed between the memorized
channels and Preset channel (descrived in next
chapter) and the priority channel. The priority channel will be scanned af-
ter each programmed channel.
3. To stop scanning, press the [ 16/9 ] or [ WX ] key.
Page 38
P-SCAN" appears on the display.
P-SCAN
P-SCAN
P-SCAN
GX2000/GX2100