Standard Horizon Matrix GX2000 Owner's Manual page 57

5. Press the [ SELECT ] soft key, then rotate the CH
knob to select the operating channel you want to
communicate on, then press the [ SELECT ] soft key.
If the channel is not shown in the list, press the
[ MANUAL ] soft key, then rotate the CHANNEL knob
to select the operating channel you want to com-
municate on, then press the [ SELECT ] soft key.
6. Press the [ YES ] soft key to transmit the individual
DSC signal.
7. When an individual call acknowledgment is received,
the established channel is automatically changed
to the channel which is selected on step 5 above
and a ringing tone sounds.
8. Press the [ QUIT ] soft key to listen to the channel to
make sure it is not busy, then press the microphone's
PTT switch and talk into the microphone to the other vessel.
Manual Calling
You may enter an MMSI number manually to contact without storing it in the
Individual Directory.
1. Press the [ CALL ( MENU )] key. The "DSC Menu
menu will appear.
2. Rotate the CHANNEL knob to select "INDIVIDUAL
(To cancel, press the [ QUIT ] soft key.)
3. Press the [ SELECT ] soft key. The transceiver will
beep, and the "Last Individual Call" will appear.
4. Press the [ NEW ID ] soft key, then select "
with the CHANNEL knob.
5. Press the [ SELECT ] soft key.
6. Rotate the CHANNEL knob to select the first num-
ber of the MMSI which you want to contact, then
press the [ SELECT ] soft key to step to the next num-
ber.
7. Repeat step 6 to set the MMSI number (nine digits).
8. If a mistake was made entering in the MMSI num-
ber, repeat pressing the [ BACK ] key until the wrong
number is selected, then rotate the CHANNEL knob
to correct the entry.
9. When finished entering the MMSI number, press and
hold the [ SELECT ] soft key.
GX2000/GX2100
DSC Menu DSC Menu" DSC Menu
DSC Menu
INDIVIDUAL INDIVIDUAL". INDIVIDUAL
INDIVIDUAL
"
MANUAL MANUAL MANUAL MANUAL MANUAL
Page 57