Mechanical Instructions - Philips 200BW8ES/00 Service Manual

1. Stand up the monitor on the electrostatic cushion, then
wear your gloves, all tools (screwdriver, both with small and
big one) prepared.
2. Put down the monitor softly, remove 1pcs screw from
bottom of base and take off it.(note: care of the panel without
scraped.)
3. Release 4pcs screws from stand and take off it.
4. Release the two screws from rear cover.
5. Release the two screws on the underside of rear cover,
then take out rear cover.
Mechnical instructions
6. Release the three screws on the left side of bezel, then
release the other three screws on the right of bezel.
7. Tear off the adhesive tape and take out the cable from the
sink of main board(note: don't do it forcibly).
8. Release the two screws on the left side of shielding, then
release the other two screws on the right side of shielding.
200BW8 LCD 13