Assembly Instructions - Impex COMPETITOR WM-357 Owner's Manual

ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Plug the two Upright End Caps (#24) onto the bottom of the Right & Left Upright
Beams (#1 & #2). Secure each Cap with a ST5 Screw (#47).
B.) Connect the two Upright Beams by a Cross Brace (#4) in the Mid-span. Secure them
with two M10 x 3 1/8" Carriage Bolts (#36), one Curved Bracket (#14), two
Washers (#43), and two M10 Aircraft Nuts (#48) on each end of the Cross Brace.
C.) Attach a Weight Post (#8) to the Right Upright Beam. Secure it with one M10 x 1"
Allen Bolt (#40) and Curved Washer (#46). Slide a 2 3/8" Rubber Bumper (#20) onto
the Weight Post. Attach a Spring Clip (#26) to the Post. Repeat the same step to
install the other side.
D.) Place the Backrest Adjustment Bar (#35) between the two Uprights to obtain desired
incline of Backrest.
5
¾"