Advertisement
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: One Adjustable Wrench and Allen Wrench
NOTE: It is strongly recommended two or more people assembling the machine to avoid
possible injury.
STEP 1
(See Explode Diagram)
A.) Attach each end of the Main Frame (#1) onto the Stabilizers (#2). Secure each end with two
M10 x 5/8" Allen Bolts (#8) and Ø ¾" Washers (#13) from the bottom of the Stabilizers.
B.) Attach the Dumbbell Frames (#3) to both sides of the Main Frame (#1). Align the holes and
secure them with two M10 x 5 ¼" Allen Bolts (#9), four Ø ¾" Washers (#13), and two M10
Aircraft Nuts (#12).
C.) Attach two L-shaped Brackets (#4) to the holes on the Main Frame (#1). Secure the Brackets
with one M10 x 4" Allen Bolt (#10), two Ø ¾" Washers (#13), and one M10 Aircraft Nut (#12).
Repeat the same procedure to install the other brackets. Do not tighten the brackets yet.
D.) Place the Seat Pad (#5) onto the Main Frame. Align the holes to the Brackets. Secure it with
six M8 x ¾" Allen Bolts (#11) and Ø 5/8" Washers (#14). Secure all Nuts and Bolts previously
installed.
EXPLODED DIAGRAM
4
Advertisement
