Travis Industries 36 CF II Owner's Manual page 9

Adjusting the Target Temperature of the Thermostat:
Make sure the remote is in thermostat mode. Press the up and down arrow buttons until the
desired temperature is displayed in the "SET" box (see illustration below).
WARNING: While in thermostat mode the fireplace will turn on and off to meet the temperature
demands of the remote. Do not place any items near the fireplace or conduct service without
shutting off gas to the fireplace.
WARNING: If the remote is set to a high temperature the fireplace may remain on for an extended
period of time. This may be a concern to those using LP (propane).
WARNING: If the remote is used as a thermostat for extended periods, make sure the batteries are
charged. We recommend replacing the batteries at the beginning of the heating season. If the
batteries go dead while in thermostat mode, the fireplace will shut off after 2 hours.
© Travis Industries
Operation
Set
Mode
Fn
4100519
9
100-01198_001