English
Here you can control the operation of the DVR's two Alarm Out
ports (NO1 and NO2).
Note that both alarm outputs on the DVR are Normally Open
(NO). If you've got an external device, it must be configured
to use a NO triggering method, otherwise they'll be in a
permanently alarmed state.
Alarm Output No.: Which alarm output(s) you'd like to use.
You can configure each independently,
The -> characters indicate that these are alarm outputs.
Hold For: The amount of time you'd like the DVR to maintain
the Alarm Output status.
Please note: depending on the configuration and intended
purpose of your external alarm device, it may or may not
continue to be in an alarmed state once the DVR's signal
has ceased.
Alarm: Alarm Output
Schedule: You can alter the alarm output to only be active on
certain days and for certain times. The schedule operates in
the same way as the recording schedule, except it contains
only two possible states.
The red squares indicate times that the alarm output condition
you've selected are active.
The white squares indicate the time that the alarm outputs are
not active.
47