Dockside Setup For Fantum Feedback Tm - Furuno NAVpilot-700 Installation Manual

3.5.2 Dockside setup for Fantum Feedback
How to set the drive unit
1. Use the knob to select [DRIVE UNIT SELECTION] then push the knob.
2. Rotate the knob to select [REVERSIVLE 24V] or [REVERSIBLE 12V] then push the
knob.
Air bleeding
Note: Air bleeding can not be performed if the drive unit has not been selected.
1. Go back to the [DOCKSIDE STUP] menu.
2. Rotate the knob to select [AIR BLEEDING] then push the knob.
3. The cursor is selecting [NO]; push the knob. Rotate the knob to select [YES] then
push the knob to show the following message.
4. Press the (or
5. Remove the appropriate rubber cap of the cylinder to bleed air.
6. Press the (or
7. Remove the appropriate rubber cap of the cylinder to bleed air.
8. Repeat steps 4-7 to bleed air completely.
DOCKSIDE SETUP
DRIVE UNIT SELECTION:
AIR BLEEDING: NO
RUDDER TEST: NO
AIR BLEEDING
AIR BLEEDING:
AIR BLEEDING
PUSH ARROW KEYS TO ENABLE
PUMPSET
PUSH MENU KEY WHEN DONE
) key until the indicator is completely filled (in black).
) key until the indicator is completely filled (in black).
TM
UNKNOWN
NO
3. INITIAL SETTINGS
3-15