Remote Controllers (Option) - Furuno NAVpilot-700 Installation Manual

1.4

Remote Controllers (option)

Two remote controllers may be connected to the Processor Unit. To connect three NFU-
(Non-Follow Up) type remote controllers (button and lever) to the Processor Unit, connect
them via the optional Distributor FAP-6800.
Keep the remote controllers away from areas subject to rain and water splash.
Note: For Fantum Feedback
Dial-type remote controller FAP-5551/FAP-5552
Fasten these remote controllers to a bulkhead. They can also be mounted on the bulk-
head by using the optional bracket assembly OP64-2 (Code No.: 009-004-030).
33
(1.3")
62
(2.44")
Bulkhead mount
For handheld operation in the opposite direction, reverse the switch and dial blocks so that
the dial is readable. To do this, loosen the four screws shown below. Note that the switch
and dial blocks are inserted into the controller body with O-rings. Be careful not to damage
them.
TM
, the remote controller can not be connected.
125
(4.92")
Bracket mount (with optional bracket assembly OP64-2)
FAP-5551, bulkhead, bracket mount
How to reverse the switch and dial blocks
1. INSTALLATION
119(4.7")
17.5
39
(0.69")
(1.54")
1-9