Before Installation; Mounting; Cable Connections - Axis 210 User Manual

Before Installation

Follow these steps to install the AXIS 210/211 on your local network (LAN):
1. Familiarize yourself with the camera - see the overview on page 7.
2. Position and mount the camera as required - see below.
3. Connect the cables - see below.
4. Assign an IP address - see Select Your Installation Method, on page 10.

Mounting

1. If required, use the 3 supplied screws
to fix the base plate to a flat surface.
2. To use the shorter stand, remove the
extension section.
3. Attach the camera to the top of the
stand.
4. Adjust the camera angle and gently
tighten the lock ring.
Important!
The AXIS 210 is designed for indoor use only, and must always be positioned where it is not exposed to
direct sunlight or strong halogen light, which can cause permanent damage to the camera's image sen-
sor. Damage as a result of exposure to strong light is not covered by the Axis warranty.
To use the AXIS 211 outdoors it must be installed in an approved outdoor enclosure. Please visit
www.axis.com for more information on enclosures.

Cable Connections

1. Connect the AXIS 210 to your network using a standard RJ-45 network cable. If using
Power over Ethernet (PoE) with the AXIS 211, this is the only connection required. Step
2 can be skipped.
2. Connect the power adapter to the camera.
AXIS 210/211 - Before Installation
Lock ring
Extension
section
9
Lock ring